10年品牌值得信賴
精誠團結、奮起拼搏、開拓進取

濟南彩鋼板

13969159292

0531-88686388

新聞中心

首頁>>新聞中心>>鋼結構構件防腐處理注意事項!
新聞中心
聯系我們
濟南堅固彩鋼工程公司

聯系人:

電話:13969159292

地址:濟南市工業北路81號北鄰

鋼結構構件防腐處理注意事項!

來源:http://www.ebassfish.com/ 日期:2021-07-15 發布人:jiangucaigang
1.在鋼結構工程中首先把鋼構件用鋼絲刷、干凈毛刷、去油污劑、經過油水分離處理過的壓縮空氣或棉紗等,將鋼材表面清理干凈并晾干.
1. In the steel structure engineering, the steel surface shall be cleaned and dried with wire brush, clean brush, degreaser, compressed air or cotton yarn after oil-water separation treatment
2.開桶前應將捅蓋上的塵土、污物等清除干凈,以防開桶時掉人桶內,開桶后應使用電動攪拌器將涂料攪拌均勻,表面漆皮則應除掉;當涂料結塊、凝膠和沉淀以至于攪拌不勻時,則說明涂料已變質,不得使用.
2. Before opening the barrel, the dust and dirt on the cover should be removed to prevent falling into the barrel when opening the barrel. After opening the barrel, the electric mixer should be used to mix the coating evenly, and the surface paint should be removed; When the coating is lump, gel and precipitate, so that the mixing is uneven, it indicates that the paint has deteriorated and can not be used.
3.涂料出廠時的黏度是在標準條件(溫度25C)下側定的,當溫度變化時,會隨溫度上升而變稀,溫度下降而變稠,同時,不同施工方法要求施工的黏度也不相同,因此施工前應調整成合適的黏度.調整黏度時應用專用稀釋劑,當需要代用時,應經試驗確定.
3. The viscosity of the paint is determined under the standard conditions (temperature 25C). When the temperature changes, it will become thinner with the rise of temperature and thicker with the fall of temperature. At the same time, the viscosity required by different construction methods is also different. Therefore, it should be adjusted to the appropriate viscosity before construction. When adjusting the viscosity, the special diluent should be used. When it needs to be replaced, it should be determined by test
4.涂裝底漆,一般根據構件的材質、形狀、尺寸大小、表面狀態、涂料品種、鋼結構工程施工現場環境和現有施工機具等因索確定涂裝方法,
4. The primer coating method is generally determined according to the material, shape, size, surface state, coating type, construction site environment of steel structure engineering and existing construction machines and tools of components,
5.底漆涂裝完畢,待實干固化后,清理油漆表面流掛、塵土、油污等物,再進行下一道油漆的涂裝,常用涂料間隔時間參見涂料廠家的推薦值確定.
5. After the primer coating is completed, the sagging, dust, oil and other substances on the paint surface shall be cleaned after the dry curing, and then the next coating shall be carried out. The interval of common coatings shall be determined according to the recommended value of the coating manufacturer
6.涂裝中間漆,中間漆可涂一遍或多遍,應根據涂料品種、鋼結構建筑施工現場環境和現有施工機具等因素確定涂裝方法.
6. Apply intermediate paint. Intermediate paint can be applied one or more times. The coating method shall be determined according to the coating type, construction site environment of steel structure building and existing construction machines and tools
7.遍中間漆涂裝完畢,待干燥后,先清理表面流掛、塵土、油污等物再進行下一道油漆的涂裝,如此反復,常用涂料間隔時間參見涂料廠家的推薦值確定
7. After the first coat of intermediate paint is finished and dried, the surface sagging, dust, oil and other substances shall be cleaned before the next coat is applied. This is repeated. The interval of common coatings shall be determined according to the recommended value of the coating manufacturer
8.面漆涂裝要求外觀均勻、平整、豐滿和有光澤,顏色應符合設計要求且無肉眼可見色差,不允許有咬底、裂紋、剝落、流掛、針孔、刷痕、起皺和順?;覊m等,宜采用滾涂法或空氣噴涂法施工.
8. The appearance of the top coat shall be uniform, flat, plump and glossy, the color shall meet the design requirements, and there shall be no visible color difference, undercut, crack, peeling, sagging, pinhole, brush mark, wrinkling and grain dust, etc. the roll coating method or air spraying method shall be adopted
9.面漆徐裝完畢,待實干、固化后,才能搬運.搬運過程中應加軟墊以保證漆膜不受損傷,當涂層有缺陷時,應及時修復,修補方法和要求應與完好涂層部分相同.
9. After the finish coat is slowly installed, it can be transported only after it is dried and cured. During the transportation, cushion shall be added to ensure that the paint film will not be damaged. When the coating has defects, it shall be repaired in time, and the repair method and requirements shall be the same as those of the intact coating
10.整個鋼結構工程安裝完后應對下列部位進行補漆,方法與原涂層相同安裝焊縫處的預留部位及燒損部分.運輸和吊裝時損傷的部分.連接部位的外露部分.其他偏涂裝的部位.涂膜厚度達不到設計要求的部位.
10. After the installation of the whole steel structure project, the following parts shall be repainted in the same way as the original coating. The reserved parts and burnt parts of the welding seam, the damaged parts during transportation and hoisting, the exposed parts of the connecting parts, other parts with partial coating, and the parts whose film thickness can not meet the design requirements shall be installed
此文關鍵詞: 濟南彩鋼板  

推薦閱讀/ Recommended reading

相信大家對彩鋼復合板都不會陌生,畢竟在生活中是比較常見的。雖然濟南彩鋼復合板引進不到20年時間,但由于其具有承力、保溫隔熱、裝飾、防

防火彩鋼板表面為什么出現壓斑? 2022-02-26
有哪些原因會導致C型鋼出現變形的現象? 2022-02-22
彩鋼瓦具有哪些優勢? 2022-02-17
復合板質量控制的措施及建議 2022-02-14
欧美激情视频-人妻av综合天堂一区-色天使色妺妺网站-无码a片